Re: [PATCH v2] power: max17042_battery: add HEALTH and TEMP_* properties support

[Krzysztof Kozlowski]

On 25.07.2015 22:23, Pallala, Ramakrishna wrote:
> Hi Krzysztof Kozlowski,
> 
>> On Tue, Jun 23, 2015 at 09:58:41AM +0900, Krzysztof Kozlowski wrote:
>>> 2015-06-08 10:22 GMT+09:00 Krzysztof Kozlowski <k.kozlowski@xxxxxxxxxxx>:
>>>> 2015-05-24 12:41 GMT+09:00 Ramakrishna Pallala <ramakrishna.pallala@xxxxxxxxx>:
>>>>> This patch adds the support for following battery properties to 
>>>> max17042 fuel gauge driver.
>>>>>
>>>>> POWER_SUPPLY_PROP_TEMP_ALERT_MIN
>>>> POWER_SUPPLY_PROP_TEMP_ALERT_MAX
>>>>> POWER_SUPPLY_PROP_TEMP_MIN
>>>>> POWER_SUPPLY_PROP_TEMP_MAX
>>>>> POWER_SUPPLY_PROP_HEALTH
>>>>
>>>> I wonder, have you tested the patch? After booting on Trats2 device
>>>> (max77693 which identifies itself as 17047-like) the values are:
>>>> POWER_SUPPLY_TEMP_ALERT_MIN=1280
>>>> POWER_SUPPLY_TEMP_ALERT_MAX=1270
>>>> POWER_SUPPLY_TEMP=257
>>>> This is okay, datasheet says that register after booting will have 
>>>> value of 0x7f80.
>>>>
>>>> However setting them to some value which should trigger interrupts 
>>>> (like 300 for MIN or 200 for MAX) does not trigger the interrupt. I 
>>>> added a printk in max17042_thread_handler().
>>>>
>>>> Is the temperature alert feature working?
>>>
>>> Can you reply to my question above?
>>> If this feature is not working, then it should be removed.
> 
>> What's the status of this? I cannot test the feature, since I don't have the hardware. I agree, that this should be removed, if it's not working.
> 
> I missed this email (may be overlooked it). To have the interrupts enabled we need the config registers(0x1Dh) bit's BIT(9), BIT(4) and BIT92) should be 1 and  BIT(8) should be 0.
> 
> Can you dump the status(00h), Talrt(02H) Temp(08h) and config(1Dh) registers values and share?

Thanks for responding. The issue was in BIT(8) which was set to default
value of 0x1. This would mean to use external sensor but the board does
not have it.

This is a DT platform and there is no initial config data so all
registers are set to default values.

Anyway everything seems to work as expected, thanks for explanation.

Best regards,
Krzysztof

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/