Re: [PATCH] spmi: add command tracepoints for SPMI

[Stephen Boyd]

On 05/18/15 14:51, Ankit Gupta wrote:
> Add tracepoints to retrieve information about read, write
> and non-data commands. For performance measurement support
> tracepoints are added at the beginning and at the end of
> transfers. Following is a list showing the new tracepoint
> events. The "cmd" parameter here represents the opcode, SID,
> and full 16-bit address.
>
> spmi_write_begin: cmd and data buffer.
> spmi_write_end  : cmd and return value.
> spmi_read_begin : cmd.
> spmi_read_end   : cmd, return value and data buffer.
> spmi_cmd        : cmd.
>
> The reason that cmd appears at both the beginning and at
> the end event is that SPMI drivers can request commands
> concurrently. cmd helps in matching the corresponding
> events.
>
> SPMI tracepoints can be enabled like:
>
> echo 1 >/sys/kernel/debug/tracing/events/spmi/enable
>
> and will dump messages that can be viewed in
> /sys/kernel/debug/tracing/trace that look like:
>
> ... spmi_read_begin: opc=56 sid=00 addr=0x0000
> ... spmi_read_end: opc=56 sid=00 addr=0x0000 ret=0 len=02 buf=0x[01-40]
> ... spmi_write_begin: opc=48 sid=00 addr=0x0000 len=3 buf=0x[ff-ff-ff]
>
> Signed-off-by: Ankit Gupta <ankgupta@xxxxxxxxxxxxxx>
> Signed-off-by: Gilad Avidov <gavidov@xxxxxxxxxxxxxx>
> Suggested-by: Sagar Dharia <sdharia@xxxxxxxxxxxxxx>
> ---

Assuming you fix sign-off-chain:

Reviewed-by: Stephen Boyd <sboyd@xxxxxxxxxxxxxx>

-- 
Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
a Linux Foundation Collaborative Project

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/