Re: [PATCH v5 WIP 5/5] paride: use new parport device model

[Sudip Mukherjee]

On Wed, May 20, 2015 at 10:07:48AM +0200, Jean Delvare wrote:
> Hi Sudip,
> 
> On Wed,  6 May 2015 15:46:17 +0530, Sudip Mukherjee wrote:
> > modify paride driver to use the new parallel port device model.
> 
> Leading capital please ;-)
yes, its the linux habit of writing in small letters. :)
> 
> > 
> > Signed-off-by: Sudip Mukherjee <sudip@xxxxxxxxxxxxxxx>
> > ---
> > 
> > +	}
> > +	par_cb->flags = 0;
> > +	par_cb->wakeup = pi_wake_up;
> > +	par_cb->private = (void *)pi;
> > +	pi->pardev = parport_register_dev_model(port, pi->device, par_cb,
> > +						unit);
> 
> If pi->device already includes the device number, and you are passing
> it again as unit, won't you end up with odd names like pcd0.0, pcd1.1,
> pcd2.2 etc?
yes, it is. This is the only driver using parport where in the probe
i had to use strncmp again.

> 
> >  	parport_put_port(port);
> > +	kfree(par_cb);
> 
> If you don't need par_cb anywhere else then you shouldn't be allocating
> it dynamically. It's small enough to fit on the stack really.
like you suggested, I will make it local in all the drivers.

regards
sudip.
> 
> -- 
> Jean Delvare
> SUSE L3 Support
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/