[PATCH v2 0/5] ARM: sunxi: Add support for USB OTG PHY

From: Roman Byshko
Date: Mon Nov 10 2014 - 13:55:28 EST


Hi,

There is already support for two USB phys, which are used for
USB host controllers on Allwinner SoC aka sunxi.

This patch series add support for the USB OTG phy (aka phy0).

The code has been tested on Allwinner A20 aka sun7i (Cubietruck).

Best regards,
Roman Byshko

Changes since v1:
* Improved comment about 45 Ohm resistor calibration
* Added Signed-off-by to all patches

Roman Byshko (5):
phy: sun4i: add support for USB phy0
ARM: dtsi: sunxi: add common VBUS regulator
ARM: sun7i: dtsi: add support for usbphy0
ARM: dts: sun7i: Cubietruck: override regulator pin
ARM: dts: sun7i: Cubietruck: add power supply regulator for USB OTG
VBUS

arch/arm/boot/dts/sun7i-a20-cubietruck.dts | 14 ++++++++++++++
arch/arm/boot/dts/sun7i-a20.dtsi | 4 ++--
arch/arm/boot/dts/sunxi-common-regulators.dtsi | 19 +++++++++++++++++++
drivers/phy/phy-sun4i-usb.c | 9 ++++++---
4 files changed, 41 insertions(+), 5 deletions(-)

--
2.1.2

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/