Re: [PATCH V2 1/2] power: twl4030_charger: detect battery presence prior to enabling charger

[Sebastian Reichel]

On Wed, Jul 23, 2014 at 02:24:20AM -0700, Tony Lindgren wrote:
> * Nishanth Menon <nm@xxxxxx> [140528 14:48]:
> > TWL4030's Battery Charger seems to be designed for non-hotpluggable
> > batteries.
> > 
> > If battery is not present in the system, BATSTS is always set with the
> > expectation that software will take actions to move to a required safe
> > state (could be power down or disable various charger paths).
> > 
> > It does not seem possible even by manipulating the edge detection
> > of the event (using BCIEDR2 register) to have a consistent hotplug
> > handling. This seems to be the result of BATSTS interrupt generated
> > when the thermistor of the battery pack is disconnected from the
> > dedicated ADIN1 pin. Clearing the status just results in the status
> > being regenerated by the monitoring ADC(MADC) and disabling the
> > edges of event just makes hotplug no longer function. The only
> > other option is to disable the detection of the MADC by disabling
> > BCIMFEN4::BATSTSMCHGEN (battery presence detector) - but then, we can
> > never again detect battery reconnection.
> > 
> > So, detect battery presence based on precharge(which is hardware
> > automatic state) or default main charger configuration at the time of
> > probe and enable charger logic only if battery was present.
> > 
> > Reported-by: Russell King <linux@xxxxxxxxxxxxxxxx>
> > Tested-by: Tony Lindgren <tony@xxxxxxxxxxx>
> > Signed-off-by: Nishanth Menon <nm@xxxxxx>
> 
> Dmitry, can we please get this first patch merged? This is needed
> on some omap3 platforms for DT based booting when no battery is
> present.
> 
> Only the second patch in this series is still being discussed AFAIK.

applied to battery-2.6.git:

http://git.infradead.org/battery-2.6.git/commit/61a7784efd3c89ffb6242f29bcee170dd7f55e6b

-- Sebastian

Attachment: signature.asc
Description: Digital signature