Re: [PATCH 2/2] sched: Fix next_balance logic in rebalance_domains() and idle_balance()

[Jason Low]

On Thu, 2014-05-08 at 19:38 +0200, Ingo Molnar wrote:
> * Jason Low <jason.low2@xxxxxx> wrote:
> 
> > On Mon, 2014-04-28 at 15:45 -0700, Jason Low wrote:
> > > Currently, in idle_balance(), we update rq->next_balance when we pull_tasks. 
> > > However, it is also important to update this in the !pulled_tasks case too.
> > > 
> > > When the CPU is "busy" (the CPU isn't idle), rq->next_balance gets computed
> > > using sd->busy_factor (so we increase the balance interval when the CPU is
> > > busy). However, when the CPU goes idle, rq->next_balance could still be set
> > > to a large value that was computed with the sd->busy_factor.
> > > 
> > > Thus, we need to also update rq->next_balance in idle_balance() in the cases
> > > where !pulled_tasks too, so that rq->next_balance gets updated without taking
> > > the busy_factor into account when the CPU is about to go idle.
> > > 
> > > This patch makes rq->next_balance get updated independently of whether or
> > > not we pulled_task. Also, we add logic to ensure that we always traverse
> > > at least 1 of the sched domains to get a proper next_balance value for
> > > updating rq->next_balance.
> > > 
> > > Additionally, since load_balance() modifies the sd->balance_interval, we
> > > need to re-obtain the sched domain's interval after the call to
> > > load_balance() in rebalance_domains() before we update rq->next_balance.
> > > 
> > > This patch adds and uses 2 new helper functions, update_next_balance() and
> > > get_sd_balance_interval() to update next_balance and obtain the sched
> > > domain's balance_interval. 
> > 
> > 
> > Hi Peter,
> > 
> > I noticed that patch 1 is in tip, but not this patch 2. I was wondering
> > what the current status with this [PATCH 2/2] is at the moment.
> 
> It was crashing the bootup with the attached config, it gave the splat 
> attached below. (ignore the line duplication, it's a serial logging 
> artifact.)

Ah okay. I'll take a look at the code some more then.

Thanks,
Jason

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/