Re: [PATCH] regmap: irq: Allow using zero value for ack_base

[Alexander Shiyan]

> On 12/15/2013 10:36 AM, Alexander Shiyan wrote:
> > In some cases, clear interrupt register may be at address 0.
> > This patch allows to use such configurations by adding additional
> > configuration bit to indicate this.
> > 
> > Signed-off-by: Alexander Shiyan <shc_work@xxxxxxx>
> > ---
> >  drivers/base/regmap/regmap-irq.c | 6 +++---
> >  include/linux/regmap.h           | 5 ++++-
> >  2 files changed, 7 insertions(+), 4 deletions(-)
...
> > diff --git a/include/linux/regmap.h b/include/linux/regmap.h
> > index e559078..3a36f61 100644
> > --- a/include/linux/regmap.h
> > +++ b/include/linux/regmap.h
...
> > @@ -520,6 +522,7 @@ struct regmap_irq_chip {
> >  	unsigned int irq_reg_stride;
> >  	bool init_ack_masked:1;
> >  	bool mask_invert:1;
> > +	bool use_ack:1;
> I think this will break something. Better use 0 as default value.
> Reason I think so, is because in the above code you effectively add a new
> possibility for most code to run.

This is not a default value but bit-size of this field.

---
èº{.nÇ+‰·Ÿ®‰­†+%ŠËlzwm…ébëæìr¸›zX§»®w¥Š{ayºÊÚë,j­¢f£¢·hš‹àz¹®w¥¢¸¢·¦j:+v‰¨ŠwèjØm¶Ÿÿ¾«‘êçzZ+ƒùšŽŠÝj"ú!¶iO•æ¬z·švØ^¶m§ÿðÃnÆàþY&—