Re: [PATCH 2/2] memory: ti-aemif: add bindings for AEMIF driver

[Grygorii Strashko]

Hi Jean-Christophe,

On 11/22/2013 08:42 PM, Jean-Christophe PLAGNIOL-VILLARD wrote:
> On 21:03 Wed 20 Nov     , ivan.khoronzhuk wrote:
>> On 11/20/2013 08:21 PM, Jean-Christophe PLAGNIOL-VILLARD wrote:
>>>> +				the chip select signal.
>>>> +				Minimum value is 1 (0 treated as 1).
>>>> +
>>>> +- ti,cs-wsetup:		write setup width, ns
>>>> +				Time between the beginning of a memory cycle
>>>> +				and the activation of write strobe.
>>>> +				Minimum value is 1 (0 treated as 1).
>>>> +
>>>> +- ti,cs-wstrobe:	write strobe width, ns
>>>> +				Time between the activation and deactivation of
>>>> +				the write strobe.
>>>> +				Minimum value is 1 (0 treated as 1).
>>>> +
>>>> +- ti,cs-whold:		write hold width, ns
>>>> +				Time between the deactivation of the write
>>>> +				strobe and the end of the cycle (which may be
>>>> +				either an address change or the deactivation of
>>>> +				the chip select signal.
>>>> +				Minimum value is 1 (0 treated as 1).
>>>> +
>>>> +If any of the above parameters are absent, current parameter value will be taken
>>>> +from the corresponding HW reg.
>>>> +
>>>> +The name for cs node must be in format csN, where N is the cs number.
>>>
>>> this is wired we should use reg instead to represent the cs as done for SPI
>>> or a an other property
>>>
>>> Best Regards,
>>> J.
>>>
>>
>> Ok, I will add new property cs-chipselect like following :
>>
>> ti,cs-chipselect:	number of chipselect. Indicates on the
>> 			aemif driver which chipselect is used
>> 			for accessing the memory.
>> 			For compatibles "ti,davinci-aemif" and
>> 			"ti,keystone-aemif" it can be in range [0-3].
>> 			For compatible "ti,omap-L138-aemif" range is [2-5].
>>
>> Is it OK?
> 
> yes
> 
> I just have one issue the whole memory concept
> 
> for me we should do as done on pinctrl have a phandle on the device that
> require it and handle it at device core level
> 
> as the memory controller is not necessarely on the same bus as the memory
> device them selves

Could you clarify your point a bit, pls?
Are you talking about external ASRAM, NOR and NAND chips wired to CS interface?

Regards,
- grygorii

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/