Re: linux-next: Tree for May 6 (b43/bcma)

[Larry Finger]

On 05/06/2013 12:42 PM, Randy Dunlap wrote:
> on x86_64:
>
> drivers/built-in.o: In function `b43_gpio_cleanup.isra.40':
> main.c:(.text+0x1b425b): undefined reference to `bcma_chipco_gpio_control'
> drivers/built-in.o: In function `b43_wireless_core_reset':
> (.text+0x1b5fb6): undefined reference to `bcma_core_set_clockmode'
> drivers/built-in.o: In function `b43_wireless_core_reset':
> (.text+0x1b6058): undefined reference to `bcma_core_pll_ctl'
> drivers/built-in.o: In function `b43_chip_init':
> main.c:(.text+0x1b8444): undefined reference to `bcma_chipco_gpio_control'
> drivers/built-in.o: In function `b43_wireless_core_init':
> main.c:(.text+0x1b887b): undefined reference to `bcma_core_pci_irq_ctl'
> drivers/built-in.o: In function `b43_bus_bcma_device_disable':
> bus.c:(.text+0x1b9d46): undefined reference to `bcma_core_disable'
> drivers/built-in.o: In function `b43_bus_bcma_device_enable':
> bus.c:(.text+0x1b9d55): undefined reference to `bcma_core_enable'
> drivers/built-in.o: In function `b43_bus_bcma_device_is_enabled':
> bus.c:(.text+0x1b9d64): undefined reference to `bcma_core_is_enabled'
> drivers/built-in.o: In function `b43_nphy_channel_setup':
> phy_n.c:(.text+0x1c8fe5): undefined reference to `bcma_pmu_spuravoid_pllupdate'
> drivers/built-in.o: In function `b43_phy_initn':
> phy_n.c:(.text+0x1cb853): undefined reference to `bcma_chipco_gpio_control'
> drivers/built-in.o: In function `b43_dma_init':
> (.text+0x1d5790): undefined reference to `bcma_core_dma_translation'
> drivers/built-in.o: In function `b43_init':
> main.c:(.init.text+0xa07a): undefined reference to `__bcma_driver_register'
> main.c:(.init.text+0xa09f): undefined reference to `bcma_driver_unregister'
> drivers/built-in.o: In function `b43_exit':
> main.c:(.exit.text+0x153a): undefined reference to `bcma_driver_unregister'
>
>
> Probably mostly due to B43=y and BCMA=m.

Does any Kconfig wizard know the magic incantation to accomplish the following:

1. Ensure that if SSB and BMCA are both selected, then both are either "m" or "y"

2. Ensure that BRCMSMAC is not "y" if BMCA is "m".

3. Ensure that B43 is not "y" if SSB and/or BCMA is "m".

Thanks,

Larry


--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/