Re: [PATCH] x86: kvm: reset the bootstrap processor when it gets anINIT

From: Gleb Natapov
Date: Mon Mar 11 2013 - 13:23:50 EST


On Mon, Mar 11, 2013 at 04:36:33PM +0100, Jan Kiszka wrote:
> On 2013-03-11 15:23, Paolo Bonzini wrote:
> > Il 11/03/2013 15:05, Gleb Natapov ha scritto:
> >> On Mon, Mar 11, 2013 at 03:01:40PM +0100, Jan Kiszka wrote:
> >>>> We are not moving away from mp_state, we are moving away from using
> >>>> mp_state for signaling because with nested virt INIT does not always
> >>>> change mp_state, not only that it can change mp_state long after signal
> >>>> is received after vmx off is done.
> >>>
> >>> Right.
> >>>
> >>> BTW, for that to happen, we will also need to influence the INIT level.
> >>> Unless I misread the spec, INIT is blocked while in root mode, and if
> >>> you deassert INIT before leaving root (vmxoff, vmenter), nothing
> >>> actually happens. So what matters is the INIT signal level at the exit
> >>> of root mode.
> >>>
> >> You are talking about INIT# signal received via CPU pin, right? I think
> >> INIT send by IPI cannot go away.
> >
> > Neither can go away. For INIT sent by IPI, 10.4.7 says:
> >
> > Only the Pentium and P6 family processors support the INIT-deassert IPI.
> > An INIT-disassert IPI has no affect on the state of the APIC, other than
> > to reload the arbitration ID register with the value in the APIC ID
> > register.
> >
> > 18.27.1 also says that "In the local APIC, NMI and INIT (except for INIT
> > deassert) are always treated as edge triggered interrupts".
> >
> >
> > For INIT#, the ICH9 chipset says that "INIT# is driven low for 16 PCI
> > clocks" when a soft reset is requested. So we can guess that INIT# is
> > also edge-triggered.
>
> Ah, ok. So, virtually, INIT stays asserted until it can be delivered in
> form of a reset or a vmexit.
>
vmexit clears it?

--
Gleb.
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/