On 12/20/2012 09:18 PM, Laxman Dewangan wrote:On Thursday 20 December 2012 10:33 PM, Stephen Warren wrote:...On 12/19/2012 11:15 PM, Laxman Dewangan wrote:On Wednesday 19 December 2012 10:30 PM, Stephen Warren wrote:On 12/18/2012 11:31 PM, Laxman Dewangan wrote:Add APB DMA requestor and serial aliases for serial controller.
There will be two serial driver i.e. 8250 based simple serial driver
and APB DMA based serial driver for higher baudrate and performace.
...This patch seems to do two things:Sure it is. Since the board files select which UARTs use the low-speedI like to have this in tegraN N.dtsi file becasue:Oh, I see. I guess the aliases make sense then.2) Add aliases for the serial ports. I have no idea why this is useful.Serial aliases are added because we want to get the port number like
/dev/ttyTHS0, /d/ttyTHS2 etc. The uarta should be /dev/ttyTHS0 and
uartc should be /dev/ttyTHS2. The port number can be found using aliases
and of_alias_get_id() in driver file:
port_number = of_alias_get_id(np, "serial");
But, wouldn't you only add aliases for the specific UARTs that are in
use on a particular board (so put them in tegraNN-board.dts) rather than
all UARTs on Tegra (i.e. the current patch which puts them into
tegraNN.dtsi)?
- This policy is not going to change the board to board. For high speed
driver the uarta will be ttyTHS0 and uartb ttyTHS1.
driver vs. the high-speed driver by overriding the compatible value,
each board will have a different subset of UARTs which use the high
speed driver and hence which use the aliases. Don't you want to end up
with /dev/ttyHS0 on each board, rather than ending up with a "random"
device node name depending on which UART the board designer picked for
the high speed device?