Re: RAID extremely slow

[Bill Davidsen]

Kevin Ross wrote:
> > > > unused devices:<none>
> > > >
> > > > # cat /proc/sys/dev/raid/speed_limit_min
> > > > 10000
> > > MD is unable to reach its minimum rebuild rate while other system
> > > activity is ongoing.  You might want to lower this number to see if that
> > > gets you out of the stalls.
> > >
> > > Or temporarily shut down mythtv.
> >
> > I will try lowering those numbers next time this happens, which will probably
> > be within the next day or two.  That's about how often this happens.
>
> Unfortunately, it has happened again, with speeds at near zero.
>
> # cat /proc/mdstat
> Personalities : [raid6] [raid5] [raid4]
> md0 : active raid6 sdh1[0] sdd1[9] sde1[10] sdb1[6] sdi1[7] sdc1[4] sdf1[3]
> sdg1[8] sdj1[1]
>        6837311488 blocks super 1.2 level 6, 512k chunk, algorithm 2 [9/9]
> [UUUUUUUUU]
>        [=>...................]  resync =  8.3% (81251712/976758784)
> finish=1057826.4min speed=14K/sec
>
> unused devices: <none>
>
> atop doesn't show ANY activity on the raid device or the individual drives.
> http://img687.imageshack.us/img687/2913/screenshotfrom201207252.png
>
> Also, I tried writing to a test file with the following command, and it hangs.
> I let it go for about 30 minutes, with no change.
>
> # dd if=/dev/zero of=test bs=1M count=1
>
> dmesg only reports hung tasks.  It doesn't report any other problems. Here's my
> dmesg output:
> http://pastebin.ca/2174778
>
> I'm going to try rebooting into single user mode, and see if the rebuild
> succeeds without stalling.
Have you set the io scheduler to deadline on all members of the array? That's 
kind of "job one" on older kernels.

--
Bill Davidsen <davidsen@xxxxxxx>
  "We have more to fear from the bungling of the incompetent than from
the machinations of the wicked."  - from Slashdot


--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/