Re: [PATCH 5/5] mmc: sdhci-s3c: setup pins using pinctrl interface

[Stephen Warren]

On 03/11/2012 06:46 AM, Thomas Abraham wrote:
> The platform specific callback to setup the sdhci pin mux and pin config
> is removed and the pinctrl subsystem interface is used to setup the
> mux and config.

> @@ -643,8 +649,13 @@ static int __devinit sdhci_s3c_probe(struct platform_device *pdev)
>  	}
>  
>  	/* Ensure we have minimal gpio selected CMD/CLK/Detect */
> -	if (pdata->cfg_gpio)
> -		pdata->cfg_gpio(pdev, pdata->max_width);
> +	pstate = pdata->max_width ? "sdhci-pcfg8" : "sdhci-pcfg4";

If the driver is going to select a single state ("sdhci-pcfg8" or
"sdhci-pcfg4" above) at probe() time and never change it (which seems
quite reasonable for an SDHCI controller), then the driver should always
use state PINCTRL_STATE_DEFAULT, and it should be up to the board to set
up the mapping table such that PINCTRL_STATE_DEFAULT sets up the pins
for either 4-bit or 8-bit as appropriate for the board.
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/