Re: [ibm-acpi-devel] [RFC] Controlling the ThinkPad battery charger

[Henrique de Moraes Holschuh]

On Tue, 10 May 2011, Pavel Machek wrote:
> Hmm, I jave a battery pack with reasonably good cells, but firmware killed
> it. IOW available for testing.

That is likely a problem with the battery pack uC, we cannot override that
using any know firmware path in the ThinkPad.

Does the thinkpad recognizes the presence of the battery pack?  If it
doesn't, the pack uC is probably dead or in safe mode, and you'd need to
hardware-hack it.

> (And who know, perhaps recalibrate command would bring it back to life?)

AFAIK, the recalibrate command really just does this:

1. sets 'force discharge' flag on EC so that it starts discharging the
   battery pack.  Discharging stops when cell voltage drops close to the
   minimum safety level.

2. sets stop threshold to 0 (100%) for that battery pack.

That way, the box will fully-drain the pack, and then charge it to full. At
that point, the recalibration is complete (the battery pack uC will
auto-calibrate itself when it notices it has hit the fully-drained and
fully-charged points).

You can monitor per-cell-group voltages through tp_smapi on a original IBM
battery pack, that functionality should still be around on the Lenovos.
Since this is not standard SBS functionality, it might not work on
non-original battery packs.

-- 
  "One disk to rule them all, One disk to find them. One disk to bring
  them all and in the darkness grind them. In the Land of Redmond
  where the shadows lie." -- The Silicon Valley Tarot
  Henrique Holschuh
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/