Re: [ibm-acpi-devel] [RFC] Controlling the ThinkPad battery charger

[Andrew Lutomirski]

On Mon, May 9, 2011 at 10:45 AM, Henrique de Moraes Holschuh
<hmh@xxxxxxxxxx> wrote:
> On Sun, 08 May 2011, Andrew Lutomirski wrote:
>> I've figured out how the ThinkPad SMAPI charge control works (at least
>> well enough to program thresholds on some models), and I'd like to get
>
> Yeah, there's a little protocol to talk to the EC, otherwise it simply
> ignores writes to the battery threshold registers.  I think you had to set
> bit 7 before you write the threshold to the relevant EC register, or
> something.  Found it by trial-and-error a long time ago, I documented it
> somewhere but never took it forward.  I never bothered to hunt down the
> force-drain/battery-select commands, though.
>
> Anyway, since SMAPI works, and is *stable* (the fact that it works from the
> A21 to the latest Lenovos tells you just how stable), which is a lot more
> than what I can say about the ACPI stuff, I didn't see any reason to mess
> with this.

I must have been unclear.  I'm using SMAPI -- I've reverse-engineered
it from a combination of tp_smapi, the mwave driver, the ancient PDF
on Lenovo's site, and trial-and-error on my X220.  (The X220 fails
requests for the start threshold that work on on the X200s.)

>> 2. Integrate it with power_supply.
>
> Only if we can make it generic enough, but yes, THIS is the better way.
>
> However, I'd prefer if you went all the way and actually hooked to the SBS
> subsystem and exposed all the battery information.  There is a way to do
> that through the ACPI DSDT (but you will have to do the rev. engineering
> yourself, as I said, smapi works just fine across so many models, that I
> never bothered with it -- it is far better supported than ACPI).
>
> It is not even difficult, just look at the methods used to expose the
> standard ACPI battery interface, then read the Smart Battery System (SBS)
> standard, and you will find out by fast trial-and-error how to map one to
> the other.  Or you can look at tp_smapi to speed things up (only, tp_smapi
> talks directly to the EC instead of doing it over ACPI).
>
> The SBS interface exposes more data about the battery, including
> per-cell-group voltage and pack microcontroller aging counters, alarms, and
> the "needs to get through the fuel-gaugue reset procedure" semasphore.

If I'm feeling really motivated, I'll look at that.  I'm currently
more interested in the charging thresholds, though, which I think is
independent of the choice of SBS vs ACPI to access the battery state.
(From a quick glance at the SBS spec, you can inhibit charging
entirely but you can't ask for thresholds.  I assume that the EC takes
care of that.  If I'm wrong, please tell me, but SMAPI seems like a
fine way to access the thresholds.)

--Andy
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/