FPGA Serial driver

From: Jerry Johns
Date: Tue Oct 20 2009 - 13:40:06 EST


Hello all,
            I'm not exactly sure which mailing list to ask this, and am hoping that this list is the correct one for which this makes sense

I have an OMAP3530 mated to an FPGA over the GPMC interface (that maps external memory to a known linear space within the OMAP) found on that chip. I have an interrupt controller on the FPGA (and mapped into virtual IRQs in Linux through irqchip and chained handlers) and a few UARTs in it as well - the UART is specifically chosen to be 16550 compatible so that it can directly be mapped as a platform device into the 8250 serial platform driver. This way, I avoid having to write a serial driver, and it is directly compatible with that in Linux.

The FPGA currently is programmed by a separate device on boot, and that process can take up to 20 seconds - hence, the custom interrupt handler and serial driver in Linux cannot really be loaded until the FPGA has completed boot. At the same time, I do not want to hold-off booting Linux till the FPGA is alive.

What is the correct solution to this? Should I just load the interrupt and serial drivers anyways (and not use them till the FPGA is up) or should I defer loading them (that doesn't seem possible for the serial at least..)?

Any ideas are much appreciated!

Thanks,
Jerry Johns
Design Engineer
Nuvation Research Corp - Canada

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/