Re: HPT374 IDE problem with 2.6.21.* kernels

From: Sergei Shtylyov
Date: Sun Jun 03 2007 - 13:35:33 EST


Geller Sandor wrote:
Hello.

The log of a typical IDE reset is available here:

http://petra.hos.u-szeged.hu/~wildy/syslog.gz

This was the worst case: the IDE bus was resetted during the system boot.

Could you try setting HPT374_ALLOW_ATA133_6 to 0 in
drivers/ide/pci/hpt366.c and rebuild/reboot the kernel?

Hi Sergei,

This looks promising. Using a vanilla 2.6.22-rc3 I was able to reproduce
the problem within a few seconds. With the above modification the machine
is running under heavy disk I/O without problems since 30 minutes...

Did it fix the problem for good?

It seems so far. There hasn't been any problem since I've applied the fix.

Sergei, do we need to disallow UDMA6 completely on HPT734 or
is it only an issue with some problematic devices (=> blacklist)?

Note that I didn't change what the old code was doing in this regard -- although the HPT374 spec does *not* say that UDMA6 is supported, it had been enabled. What have *really* changed for HPT374 was:

- in 2.6.20-rc1, the driver switched to using the actual 33 MHz timing table
instead of the old one, matching 50 MHz (and so, severely underclocked);

- in 2.6.2-rc1, the driver switched from 33 MHz PCI to 66 MHz DPLL clock.

Disallowing UDMA6 would clock the chip with 50 MHz DPLL, howewer, the original report claimed that something has changed to worse between 2.6.21.1 and .3 but nothing changed in drivers/ide/ between those releases...

Either way we need to fix it somehow for 2.6.22.

For the record: this HTP374 is running with a quite outdated firmware (1.22) - maybe newer firmwares work correctly. I'm going to upgrade the firmware to the latest one (which was released in 2004...), but unfortunately in the upcoming 2-3 weeks I won't have access to this machine, so I can't check the case within the release cycle of 2.6.22. If you were interested I would post the result of the firmware upgrade.

I don't think this will matter...

Regards,
Sandor

MBR, Sergei
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/