Re: [PATCH] NS16550A: Restore HS settings in EXCR2 on resume

[Alan Cox]

On Thu, 17 May 2007 14:27:39 +0800
David Woodhouse <dwmw2@xxxxxxxxxxxxx> wrote:

> After a suspend/resume cycle, the UART may have been reset into
> low-speed mode -- either because it's actually been reset, or because
> the firmware pokes at the old-style divisor registers. If we detected it
> as a NS16550A SuperIO chip in the first place and set baud_base to
> 921600, then we should do so again in the resume path.
> 
> This patch adds that code to serial8250_resume_port(), and also makes
> serial8250_resume() actually call serial8250_resume_port() for each port
> instead of just calling uart_resume_port() directly. And thus fixes
> serial port operation after suspend/resume.
> 
> It also fixes a bogus comment where we write the EXCR2 register with a
> comment saying /* EXCR1 */
> 
> Signed-off-by: David Woodhouse <dwmw2@xxxxxxxxxxxxx>

Acked-by: Alan Cox <alan@xxxxxxxxxx>

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/