Re: [PATCH] i2c: adds support for i2c bus on 8xx

[Jean Delvare]

Hi Vitaly,

On Thu, 10 May 2007 14:35:54 +0400, Vitaly Bordug wrote:
> On Thu, 10 May 2007 11:28:35 +0200 Jean Delvare wrote:
> > On Tue, 08 May 2007 10:31:31 +0400, Vitaly Bordug wrote:
> > > Interface has been reworked to of_device as well as other feedback
> > > addressed. Repeated start ability is missing from the
> > > implementation.
> > 
> > Did you check the hardware documentation? Is it a hardware limitation?
> > It is likely to cause problems, so it should be investigated, and if
> > it really cannot be fixed, then this must be clearly documented (in
> > Kconfig and in the driver) and the advertised functionalities  of the
> > driver should be reduced accordingly (most SMBus transactions include
> > a repeated start.)
>
> Yes, I've checked RM about I2C controller, and cannot find anything about repeated
> start. There are a few words about multi-master considerations, that SoC features bus arbitration,
> but to avoid collisions, "higher-level handshake protocol must be used" (MPC885 RM, p. 32-6).

After reading the MPC885 RM datasheet, I think the device supports
repeated start. I guess that you simply need to _only_ set the
BD_SC_LAST flag for the last message of the transaction, not all of
them as the driver does. If I am correct, this should be fairly easy to
fix. Please try, test and report.

> > > +static int cpm_iic_init(struct i2c_adapter *adap)
> > > +{
> > > (...)
> > > +	/* Initialize Tx/Rx parameters.
> > > +	 */
> > > +	if (cpm->reloc == 0) {
> > > +		cpm8xx_t *cp = cpm->cp;
> > > +		int res;
> > > +
> > > +		u16 v = mk_cr_cmd(CPM_CR_CH_I2C, CPM_CR_INIT_TRX) | CPM_CR_FLG;
> > > +
> > > +		out_be16(&cp->cp_cpcr, v);
> > > +		res = wait_event_timeout(iic_wait,
> > > +					 !(in_be16(&cp->cp_cpcr) & CPM_CR_FLG),
> > > +					 HZ * 10);
> > 
> > This is a pretty long timeout. Can it realistically take that long?
>
> In fact, it can. Especially when CPM is loaded with Ethernet/UART/Etc
> transactions. If you feel it is overkill and I2C shouldn't do that,
> I'll trim it down though.

No, if you think it's reasonable, fine with me.

-- 
Jean Delvare
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/