Re: ALSA on MIPS platform

[Martin Michlmayr]

* Takashi Iwai <tiwai@xxxxxxx> [2006-01-30 11:18]:
> Well, as Hugu pointed out, that page reservation plays no longer any
> role.  The patch below should work too on 2.6.15 or later.

It doesn't solve the problem I have, those "wait source ready timeout
0x1410 [0x8c8c8c8c]" messages on a Cobalt Qube2 with a 64-bit MIPS
kernel.


Detecting hardware: de4x5 via82cxxx es1371 usb_uhci
de4x5 disabled in configuration.
Skipping unavailable/built-in via82cxxx module.
Skipping unavailable/built-in es1371 module.
Loading uhci_hcd module.
usbcore: registered new driver usbfs
usbcore: registered new driver hub
USB Universal Host Controller Interface driver v2.3
uhci_hcd 0000:00:09.2: Found HC with no IRQ.  Check BIOS/PCI 0000:00:09.2 setup!
uhci_hcd 0000:00:09.2: init 0000:00:09.2 fail, -19
Running 0dns-down to make sure resolv.conf is ok...done.
Setting up networking...done.
Starting hotplug subsystem:
   pci     
     uhci-hcd: already loaded
wait source ready timeout 0x1410 [0x8c8c8c8c]  <- repeated 180 times
AC'97 0 analog subsections not ready
wait source ready timeout 0x1410 [0x8c8c8c8c] <- repeated 453 times
     snd-ens1371: loaded successfully
   pci      [success]
   usb     
   usb      [success]
   isapnp  
   isapnp   [success]
   ide     
   ide      [success]
   input   
   input    [success]
   scsi    
   scsi     [success]
done.
Setting up IP spoofing protection: rp_filter.
Configuring network interfaces...done.
Starting portmap daemon: portmap.

-- 
Martin Michlmayr
http://www.cyrius.com/
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/