Re: bad pmd filemap.c, oops; 2.4.30 and 2.4.32

[Willy Tarreau]

On Sat, Dec 31, 2005 at 02:39:43AM -0800, Chris Stromsoe wrote:
> On Sat, 31 Dec 2005, Willy Tarreau wrote:
> >On Fri, Dec 30, 2005 at 05:48:15PM -0800, Chris Stromsoe wrote:
> >
> >>I'm starting to suspect bad hardware.  Booting is now hanging (with 
> >>2.4.27, 2.4.30 and 2.4.32) after scsi drivers load:
> >
> >And nothing changed since previous boot, except UP ?
> 
> All I changed was adding nosmp to the kernel boot line.

OK maybe interrupts don't get distributed to the remaining CPU, which
would explain your timeouts.

> >It's not necessarily bad hardware. I also had trouble on one version of 
> >the 29160 bios where it hanged during device scan if there were too many 
> >terminations. Oh, BTW, please check that you have disabled "automatic" 
> >termination in the BIOS. Manually set it either to ON or OFF (low/high 
> >depending on your setup).
> 
> I'll have to check it tomorrow or on Monday.
> 
> >>How likely is it that a failing scsi controller contribute to the other 
> >>problems I was seeing?
> >
> >Not much. Perhaps at worst, a failing controller could corrupt memory by 
> >writing garbage at wrong locations, but you would not always get the 
> >same messages. It seems to be a different problem here. To be honnest, 
> >it's where I think you should try the new driver.
> 
> The machine has been running 2.6.14.4 for the last 6 hours.  It came up 
> fine.  I did not try booting it with nosmp.  If I have time, I will 
> revert back to 2.4 with the newer driver to test.

Thanks.

> -Chris

Willy

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/