[2.6.13] pktcdvd: IO-errors

[Guennadi Liakhovetski]

Hi all

Just tried pktcdvd on 2.6.13.1. The setup went fine:

20:33:13: pktcdvd: writer pktcdvd0 mapped to hdc
20:33:21: pktcdvd: inserted media is CD-RW
20:33:21: pktcdvd: Fixed packets, 32 blocks, Mode-2 disc
20:33:21: pktcdvd: Max. media speed: 10
20:33:21: pktcdvd: write speed 10x
20:33:21: pktcdvd: 590528kB available on disc
20:33:23: UDF-fs INFO UDF 0.9.8.1 (2004/29/09) Mounting volume 'LinuxUDF', timestamp 2005/09/24 20:18 (1078)

But, as I tried to copy some files to the CD-RW, it first went ok, but 
then produced the following:

20:41:01: ide-cd: cmd 0x2a timed out
		      ^^^^	---------> write10
20:41:01: hdc: DMA timeout retry
20:41:01: hdc: timeout waiting for DMA
20:41:01: hdc: status timeout: status=0xd0 { Busy }
20:41:01: ide: failed opcode was: unknown
20:41:01: hdc: drive not ready for command
20:41:31: hdc: ATAPI reset timed-out, status=0x80
20:42:06: ide1: reset timed-out, status=0x80
20:42:06: hdc: status timeout: status=0x80 { Busy }
20:42:06: ide: failed opcode was: unknown
20:42:06: hdc: drive not ready for command
20:42:36: hdc: ATAPI reset timed-out, status=0x80
20:43:07: : I/O error, dev hdc, sector 136672
20:43:07: end_request: I/O error, dev hdc, sector 136680
20:43:07: end_request: I/O error, dev hdc, sector 136688
20:43:07: end_request: I/O error, dev hdc, sector 136696
20:43:07: end_request: I/O error, dev hdc, sector 137216
20:43:07: end_request: I/O error, dev hdc, sector 137224
20:43:07: end_request: I/O error, dev hdc, sector 137232
20:43:07: end_request: I/O error, dev hdc, sector 137240
... <thousands of the above>
20:43:11: end_request: I/O error, dev hdc, sector 344440
20:43:11: end_request: I/O error, dev hdc, sector 344444
20:43:11: pktcdvd: bb 00 06 ea 06 ea 00 00 00 00 00 00 - sense 00.e0.0e (No sense)
20:43:11: end_request: I/O error, dev hdc, sector 363008
20:43:11: end_request: I/O error, dev hdc, sector 363016
... <more of them>
20:43:11: printk: 79693 messages suppressed.
20:43:11: Buffer I/O error on device pktcdvd0, logical block 90752
20:43:11: lost page write due to I/O error on pktcdvd0
20:43:11: end_request: I/O error, dev hdc, sector 362880
20:43:11: end_request: I/O error, dev hdc, sector 362884
...

the "cp" finished earlier, I did a sync, and it also finished. The good 
parts - no Oops, no process stuck in "D", tha bad parts - it didn't 
work:-), the IDE LED stays on and I cannot eject the CD. The CD-R is a 
BenQ 52x32x52 Seamless Link alone on ide1, the disk does indeed say 
4x-10x. The cd-writer works mostly... if I am gentle to it - I usually 
burn at 32x even if the media says 52x... Is it just a hw-failure or a 
driver bug?

Thanks
Guennadi
---
Guennadi Liakhovetski
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/