Re: Sandisk Compact Flash

From: somshekar . c . kadam
Date: Wed Aug 03 2005 - 00:38:24 EST






HI David ,

Thanks a Lot for clearing all the doubts , yes its the drawback of my
hardware which i cant use high speed compact flash as DMA is not supported
,

Is there anyway with the help of software to message that , this compact
flash cant be used anymore , first of all is this a good idea to have such
a functinality on embedded system of saying compact flash is going to die
please replace it , or just by the number of years of compact flash we say
replace the compact flash

Thanks In Advance
Somshekar



(Embedded David Hinds <dhinds@xxxxxxxxx>
image moved 07/20/2005 09:56 PM
to file:
pic18875.pcx)





To: somshekar.c.kadam@xxxxxxxxxx
cc: linux-kernel@xxxxxxxxxxxxxxx
Subject: Re: Sandisk Compact Flash

Security Level:? Internal

On Wed, Jul 20, 2005 at 12:49:00PM +0530, somshekar.c.kadam@xxxxxxxxxx
wrote:
>
> Hi David ,
>
> On my controller CF INPACK pin is connected to 3.3v. so Comapct
> flash with DMA capabilty will not be supported , i understood this .
> but i did not undesrtand why only PIO mode 1 is supported is it ,
> why not PIO mode 4 , is it a limitation of pcmcia driver , correct
> me if i am wrong

The 16-bit PCMCIA bus is maxed out at about 1 MB/sec; that's all the
bandwidth there is. What your card supports is irrelevant.

I'm not sure whether the PCMCIA mode actually corresponds to any of
the official PIO modes 0, 1, etc. It is just "slow".

-- Dave




Attachment: pic18875.pcx
Description: Binary data