Re: [PATCH] - Initial dothan speedstep support

[Pavel Machek]

Hi!

> So here's a patch on top of the above patch that adds all of the
> dothan frequency/voltages for processors 715, 725, 735, 745, 755
> 
> Tested and working as it should so far with a 745. The stepping in the
> model table for the others may need to be tweaked.
> 
> The Dothan processor datasheet 30218903.pdf defines 4 voltages for
> each frequency (VID#A through VID#D) whereas Banias only suggests a
> typical voltage and no min or max for each freq so i've used the OP
> macro to allow definition of all voltages (A through D) but the macro
> currently just uses VID#C at compile time (the second lowest voltage
> profile).

I thought that whether to use VID#A, B, C or D depends on
your concrete chip? Not all chips are certified to run on VID#C...
				Pavel
-- 
64 bytes from 195.113.31.123: icmp_seq=28 ttl=51 time=448769.1 ms         

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/