Re: [PATCH] ide-dma.c, ide.c, ide.h, kernel 2.4.24

[Bartlomiej Zolnierkiewicz]

On Tuesday 27 of January 2004 06:52, Glenn Wurster wrote:
> > Glenn, your patch hides potential problems - these functions shouldn't be
> > called if host doesn't support DMA.  However there is one place when
> > ->ide_dma_host_off() shouldn't be called unconditionally, here is a
> > patch. It is not pretty but at least consistent - we check
> > hwif->ide_dma_check to see if DMA is supported in other places too.  Does
> > it fix the problem?
>
> Not quite.  If we go forward with a patch like that, then it must be
> updated to include at least two other places that I know of

Doh.  I overlooked one place.
IMO this check needs to be added only to two places.

> immediately.  The updated patch would be something similar to the one
> at the bottom of this e-mail.

Did you test this patch?

> On a further note, how should hdparm -d behave on my controller, the
> relivant lines from dmesg are:
>
> SIS5513: IDE controller at PCI slot 00:01.1
> SIS5513: chipset revision 8
> SIS5513: not 100% native mode: will probe irqs later
> SIS5513: SiS551x ATA 16 controller
>     ide0: BM-DMA at 0xf870-0xf877, BIOS settings: hda:pio, hdb:pio
> SIS5513: simplex device: DMA disabled
> ide1: SIS5513 Bus-Master DMA disabled (BIOS)
> hda: WDC AC21000H, ATA DISK drive
> hdc: Maxtor 6Y080L0, ATA DISK drive
>
> "hdparm -d 1 /dev/hdc" returns an operation not permitted, but "hdparm
> -d 1 /dev/hda" is successful and results in future calls to "hdparm -d
> 1 /dev/hdc" seemingly locking the computer.

I suspect that this is caused by unfinished handling of simplex devices
in setup-pci.c (simplex host - one DMA engine but two channels).

> @@ -980,10 +981,13 @@
>  	drive->id->dma_1word &= ~0x0F00;
>
>  #if defined(CONFIG_BLK_DEV_IDEDMA) && !defined(CONFIG_DMA_NONPCI)
> -	if (speed >= XFER_SW_DMA_0)
> -		hwif->ide_dma_host_on(drive);
> -	else
> -		hwif->ide_dma_off_quietly(drive);
> +	if (speed >= XFER_SW_DMA_0) {
> +		if (hwif->ide_dma_check) /* Check if host supports DMA */
> +			hwif->ide_dma_host_on(drive);

I've seen this and decided that it is not needed.

If we try to program drives to DMA on non-DMA host
something is going wrong and it is better to just OOPS.

> +	} else {
> +		if (hwif->ide_dma_check) /* Check if host supports DMA */
> +			hwif->ide_dma_off_quietly(drive);
> +	}

Yep, I've missed this one.

Thanks,
--bart

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/