[2.6.0-test11: PCMCIA] i82365: No such device...

[Guennadi Liakhovetski]

Short: under 2.4 the i82365 detects and serves the chip, under 2.6 - it
doesn't.

It's the same Toshiba Satellite 300CDT (lspci -vv below). pcmcia_core
compiled with cardbus support. In BIOS one can configure PCMCIA as 16bit
PCIC compatible, in which case it "works" - without hot-plugging. So, if
you boot with a card in the slot, it will be recognised, otherwise - not.
Next possibility "Auto-selected" (didn't really try, but didn't look too
promising), and 16bit card-bus. The latter option works under 2.4 with
i82365 and cardbus support. Under 2.6 it says: "Intel PCIC probe: not
found". Or should I be using yenta? It's not 32bit, so, didn't even try.
Ideas?

# lspci -vv
00:00.0 Host bridge: Toshiba America Info Systems 601 (rev 2c)
	Subsystem: Toshiba America Info Systems: Unknown device 0001
	Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
	Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort+ >SERR- <PERR-
	Latency: 0, cache line size 08

...

00:13.0 CardBus bridge: Toshiba America Info Systems ToPIC95 (rev 07)
	Subsystem: Toshiba America Info Systems: Unknown device 0001
	Control: I/O- Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
	Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=slow >TAbort- <TAbort- <MAbort- >SERR- <PERR-
	Interrupt: pin A routed to IRQ 11
	Region 0: Memory at 10000000 (32-bit, non-prefetchable) [disabled] [size=4K]
	Bus: primary=00, secondary=01, subordinate=04, sec-latency=0
	I/O window 0: 00000000-00000003 [disabled]
	I/O window 1: 00000000-00000003 [disabled]
	BridgeCtl: Parity- SERR- ISA- VGA- MAbort- >Reset- 16bInt- PostWrite-
	16-bit legacy interface ports at 0001

00:13.1 CardBus bridge: Toshiba America Info Systems ToPIC95 (rev 07)
	Subsystem: Toshiba America Info Systems: Unknown device 0001
	Control: I/O- Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
	Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=slow >TAbort- <TAbort- <MAbort- >SERR- <PERR-
	Interrupt: pin B routed to IRQ 11
	Region 0: Memory at 10001000 (32-bit, non-prefetchable) [disabled] [size=4K]
	Bus: primary=00, secondary=05, subordinate=08, sec-latency=0
	I/O window 0: 00000000-00000003 [disabled]
	I/O window 1: 00000000-00000003 [disabled]
	BridgeCtl: Parity- SERR- ISA- VGA- MAbort- >Reset- 16bInt- PostWrite-
	16-bit legacy interface ports at 0001

Thanks
Guennadi
---------------------------------
Guennadi Liakhovetski, Ph.D.
DSA Daten- und Systemtechnik GmbH
Pascalstr. 28
D-52076 Aachen
Germany

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/