Re: via-rhine on 2.4.23-pre6 Too much work at interrupt, status=0x00001000. (fwd)

From: John Wong
Date: Sun Oct 19 2003 - 01:14:26 EST


Hi,

I took a slightly different route, and updated the kernel to 2.4.23-pre7
and disabled ACPI. The problem did reoccur, so this would rule out
ACPI. I will downgrade the kernel to pre2 now.

Oct 18 21:46:58 cyclops kernel: eth0: Too much work at interrupt,
status=0x00001000.

John

On Fri, Oct 17, 2003 at 06:09:02PM -0400, Jeff Garzik wrote:
> >Date: Thu, 16 Oct 2003 12:27:17 -0700
> >From: John Wong <kernel@xxxxxxxxxxx>
> >To: linux-kernel@xxxxxxxxxxxxxxx
> >Subject: via-rhine on 2.4.23-pre6 Too much work at interrupt,
> > status=0x00001000.
> >
> >The system used to run 2.4.22 and did not have this too much work
> >problem. There were some other hardware changes. The system used to be
> >a Pentium 100 on a Triton 430FX chipset Intel Advanced/EV board. Now it
> >is a K6 2 - 500 on a Via Apollo MVP3 chipset on FIC VA-503+ board.
> >The NIC stayed the same. The kernel was recompiled and ACPI was
> >enabled.
> >
> >I noticed in 2.4.23-pre2 -> pre3
> > [netdrvr] sync with 2.5: epic100, fealnx, via-rhine, winbond-840
>
>
> This cset contains no functional via-rhine changes... First thing to do
> would be try to 2.4.23-pre2. But my main suspect would be ACPI.
>
> Jeff
>
>
>
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/