On Thu, Jun 05, 2003 at 06:07:04PM -0400, Alan Cox wrote:
> > just couldn't find _any_ other SiI3112 SATA card on the market in this
> > country. I don't run Red Hat or SuSE, and particularly not their
> > kernels -- (I normally run Alan's kernels). Does this mean that I've
> > bought a pig in a poke?
>
> If its a standard SI3112 series device with a different device ID then it
> ought to work just by adding the ids to the driver.
Like the patch below?
I've assumed that it's exactly like a SiI3112 in making these
changes. The kernel now recognises the device, and I can (e.g.) run
cfdisk. However, any read or write on the disk causes huge delays, and
these:
Jun 7 17:55:47 src@vlad kernel: hda: dma_timer_expiry: dma status == 0x24
Jun 7 17:55:57 src@vlad kernel: hda: DMA interrupt recovery
Jun 7 17:55:57 src@vlad kernel: hda: lost interrupt
I don't have the knowledge to determine whether this is similar to
the SiI3112 problems people have been having elsewhere, or if it's a
different cause due to something funny that Adaptec did when building
the controller.
Note, however, that the 'hdparm -X66 -d1' doesn't fix the lost
interrupt problem, nor does the 'echo "max_kb_per_request:15" >
/proc/ide/hde/settings'. I haven't tried Andre's suggestion of
drive->id->hwconfig |= 0x6000, because it's not clear to me where in
the code the line should go.
After running the hdparm command to set UDMA, I can get the
following output:
vlad:/dev/ide# hdparm -i /dev/ide/host0/bus0/target0/lun0/disc
/dev/ide/host0/bus0/target0/lun0/disc:
Model=ST3120026AS, FwRev=3.05, SerialNo=3JT059GT
Config={ HardSect NotMFM HdSw>15uSec Fixed DTR>10Mbs RotSpdTol>.5% }
RawCHS=16383/16/63, TrkSize=0, SectSize=0, ECCbytes=4
BuffType=unknown, BuffSize=8192kB, MaxMultSect=16, MultSect=16
CurCHS=65535/1/63, CurSects=4128705, LBA=yes, LBAsects=234441648
IORDY=on/off, tPIO={min:240,w/IORDY:120}, tDMA={min:120,rec:120}
PIO modes: pio0 pio1 pio2 pio3 pio4
DMA modes: mdma0 mdma1 *mdma2
UDMA modes: udma0 udma1 udma2
AdvancedPM=no WriteCache=enabled
Drive conforms to: ATA/ATAPI-6 T13 1410D revision 2: 1 2 3 4 5 6
FWIW, the hard drive is a 120Gb Seagate Barracuda V. The machine
I'm running all this on is a K6-2/500, and I don't have APIC or ACPI
support built into this kernel.
Hugo.
diff -ur -X patch-help/ignore linux-2.4.21-rc7-ac1/drivers/ide/pci/siimage.c linux-test/drivers/ide/pci/siimage.c
--- linux-2.4.21-rc7-ac1/drivers/ide/pci/siimage.c 2003-06-05 12:02:22.000000000 +0100
+++ linux-test/drivers/ide/pci/siimage.c 2003-06-07 13:26:59.000000000 +0100
@@ -172,6 +172,7 @@
switch(hwif->pci_dev->device) {
case PCI_DEVICE_ID_SII_3112:
+ case PCI_DEVICE_ID_ADAPTEC_1210SA:
/* FIXME: should we pick UDMA100 for
Maxtor devices in case its on a PATA adapter ? */
return 4;
@@ -367,7 +368,8 @@
ultra &= ~0x3F;
scsc = ((scsc & 0x30) == 0x00) ? 0 : 1;
- scsc = (hwif->pci_dev->device == PCI_DEVICE_ID_SII_3112) ? 1 : scsc;
+ scsc = (hwif->pci_dev->device == PCI_DEVICE_ID_SII_3112
+ || hwif->pci_dev->device == PCI_DEVICE_ID_ADAPTEC_1210SA) ? 1 : scsc;
switch(speed) {
case XFER_PIO_4:
@@ -674,7 +676,8 @@
if (drive->media != ide_disk)
return;
- if (HWIF(drive)->pci_dev->device == PCI_DEVICE_ID_SII_3112) {
+ if (HWIF(drive)->pci_dev->device == PCI_DEVICE_ID_SII_3112
+ || HWIF(drive)->pci_dev->device == PCI_DEVICE_ID_ADAPTEC_1210SA) {
drive->special.b.set_geometry = 0;
drive->special.b.recalibrate = 0;
}
@@ -734,7 +737,8 @@
static void proc_reports_siimage (struct pci_dev *dev, u8 clocking, const char *name)
{
- if (dev->device == PCI_DEVICE_ID_SII_3112)
+ if (dev->device == PCI_DEVICE_ID_SII_3112
+ || dev->device == PCI_DEVICE_ID_ADAPTEC_1210SA)
goto sata_skip;
printk(KERN_INFO "%s: BASE CLOCK ", name);
@@ -800,7 +804,8 @@
pci_set_drvdata(dev, ioaddr);
addr = (unsigned long) ioaddr;
- if (dev->device == PCI_DEVICE_ID_SII_3112) {
+ if (dev->device == PCI_DEVICE_ID_SII_3112
+ || dev->device == PCI_DEVICE_ID_ADAPTEC_1210SA) {
writel(0, addr + 0x148);
writel(0, addr + 0x1C8);
}
@@ -838,7 +843,8 @@
writel(0x43924392, addr + 0xE8);
writel(0x40094009, addr + 0xEC);
- if (dev->device == PCI_DEVICE_ID_SII_3112) {
+ if (dev->device == PCI_DEVICE_ID_SII_3112
+ || dev->device == PCI_DEVICE_ID_ADAPTEC_1210SA) {
writel(0xFFFF0000, addr + 0x108);
writel(0xFFFF0000, addr + 0x188);
writel(0x00680000, addr + 0x148);
@@ -976,7 +982,8 @@
hw.io_ports[IDE_IRQ_OFFSET] = 0;
- if (dev->device == PCI_DEVICE_ID_SII_3112) {
+ if (dev->device == PCI_DEVICE_ID_SII_3112
+ || dev->device == PCI_DEVICE_ID_ADAPTEC_1210SA) {
base = (unsigned long) addr;
if(ch)
base += 0x80;
@@ -993,7 +1000,8 @@
memcpy(&hwif->hw, &hw, sizeof(hw));
memcpy(hwif->io_ports, hwif->hw.io_ports, sizeof(hwif->hw.io_ports));
- if (hwif->pci_dev->device == PCI_DEVICE_ID_SII_3112) {
+ if (hwif->pci_dev->device == PCI_DEVICE_ID_SII_3112
+ || hwif->pci_dev->device == PCI_DEVICE_ID_ADAPTEC_1210SA) {
memcpy(hwif->sata_scr, hwif->hw.sata_scr, sizeof(hwif->hw.sata_scr));
memcpy(hwif->sata_misc, hwif->hw.sata_misc, sizeof(hwif->hw.sata_misc));
}
@@ -1035,7 +1043,8 @@
hwif->hwif_data = 0;
hwif->rqsize = 128;
- if (dev->device == PCI_DEVICE_ID_SII_3112 && !class_rev)
+ if ((dev->device == PCI_DEVICE_ID_SII_3112
+ || dev->device == PCI_DEVICE_ID_ADAPTEC_1210SA) && !class_rev)
hwif->rqsize = 16;
if (pci_get_drvdata(dev) == NULL)
@@ -1082,7 +1091,8 @@
hwif->reset_poll = &siimage_reset_poll;
hwif->pre_reset = &siimage_pre_reset;
- if(hwif->pci_dev->device == PCI_DEVICE_ID_SII_3112)
+ if(hwif->pci_dev->device == PCI_DEVICE_ID_SII_3112
+ || hwif->pci_dev->device == PCI_DEVICE_ID_ADAPTEC_1210SA)
hwif->busproc = &siimage_busproc;
if (!hwif->dma_base) {
@@ -1095,7 +1105,8 @@
hwif->mwdma_mask = 0x07;
hwif->swdma_mask = 0x07;
- if (hwif->pci_dev->device != PCI_DEVICE_ID_SII_3112)
+ if (hwif->pci_dev->device != PCI_DEVICE_ID_SII_3112
+ && hwif->pci_dev->device != PCI_DEVICE_ID_ADAPTEC_1210SA)
hwif->atapi_dma = 1;
hwif->ide_dma_check = &siimage_config_drive_for_dma;
@@ -1159,6 +1170,7 @@
static struct pci_device_id siimage_pci_tbl[] __devinitdata = {
{ PCI_VENDOR_ID_CMD, PCI_DEVICE_ID_SII_680, PCI_ANY_ID, PCI_ANY_ID, 0, 0, 0},
{ PCI_VENDOR_ID_CMD, PCI_DEVICE_ID_SII_3112, PCI_ANY_ID, PCI_ANY_ID, 0, 0, 1},
+ { PCI_VENDOR_ID_CMD, PCI_DEVICE_ID_ADAPTEC_1210SA, PCI_ANY_ID, PCI_ANY_ID, 0, 0, 2},
{ 0, },
};
diff -ur -X patch-help/ignore linux-2.4.21-rc7-ac1/drivers/ide/pci/siimage.h linux-test/drivers/ide/pci/siimage.h
--- linux-2.4.21-rc7-ac1/drivers/ide/pci/siimage.h 2003-06-06 09:08:57.000000000 +0100
+++ linux-test/drivers/ide/pci/siimage.h 2003-06-07 13:37:41.000000000 +0100
@@ -73,6 +73,19 @@
.enablebits = {{0x00,0x00,0x00}, {0x00,0x00,0x00}},
.bootable = ON_BOARD,
.extra = 0,
+ },{ /* 2 */
+ .vendor = PCI_VENDOR_ID_CMD,
+ .device = PCI_DEVICE_ID_ADAPTEC_1210SA,
+ .name = "Adaptec AAR-1210SA",
+ .init_chipset = init_chipset_siimage,
+ .init_iops = init_iops_siimage,
+ .init_hwif = init_hwif_siimage,
+ .init_dma = init_dma_siimage,
+ .channels = 2,
+ .autodma = AUTODMA,
+ .enablebits = {{0x00,0x00,0x00}, {0x00,0x00,0x00}},
+ .bootable = ON_BOARD,
+ .extra = 0,
},{
.vendor = 0,
.device = 0,
diff -ur -X patch-help/ignore linux-2.4.21-rc7-ac1/include/linux/pci_ids.h linux-test/include/linux/pci_ids.h
--- linux-2.4.21-rc7-ac1/include/linux/pci_ids.h 2003-06-05 12:02:27.000000000 +0100
+++ linux-test/include/linux/pci_ids.h 2003-06-06 08:51:42.000000000 +0100
@@ -761,6 +761,7 @@
#define PCI_DEVICE_ID_SUN_HUMMINGBIRD 0xa001
#define PCI_VENDOR_ID_CMD 0x1095
+#define PCI_DEVICE_ID_ADAPTEC_1210SA 0x0240
#define PCI_DEVICE_ID_CMD_640 0x0640
#define PCI_DEVICE_ID_CMD_643 0x0643
#define PCI_DEVICE_ID_CMD_646 0x0646
--
=== Hugo Mills: hugo@... carfax.org.uk | darksatanic.net | lug.org.uk ===
PGP key: 1C335860 from wwwkeys.eu.pgp.net or http://www.carfax.org.uk
--- Never underestimate the bandwidth of a Volvo filled ---
with backup tapes.
This archive was generated by hypermail 2b29 : Sat Jun 07 2003 - 22:00:33 EST