Linux version 2.4.21-pre7.200304152 (root@kalimero.eyetronics.com) (gcc version 3.2.3 20030309 (Debian prerelease)) #1 SMP Tue Apr 15 21:41:21 CEST 2003 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 000000000009f000 (usable) BIOS-e820: 000000000009f000 - 00000000000a0000 (reserved) BIOS-e820: 00000000000ca000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 000000003ff80000 (usable) BIOS-e820: 000000003ff80000 - 0000000040000000 (reserved) BIOS-e820: 00000000fec00000 - 00000000fec04000 (reserved) BIOS-e820: 00000000fee00000 - 00000000fee01000 (reserved) BIOS-e820: 00000000fff80000 - 0000000100000000 (reserved) 127MB HIGHMEM available. 896MB LOWMEM available. found SMP MP-table at 000f7160 hm, page 000f7000 reserved twice. hm, page 000f8000 reserved twice. hm, page 0009f000 reserved twice. hm, page 000a0000 reserved twice. On node 0 totalpages: 262016 zone(0): 4096 pages. zone(1): 225280 pages. zone(2): 32640 pages. Intel MultiProcessor Specification v1.4 Virtual Wire compatibility mode. OEM ID: TYAN Product ID: PAULANER APIC at: 0xFEE00000 Processor #1 Pentium(tm) Pro APIC version 16 Processor #0 Pentium(tm) Pro APIC version 16 I/O APIC #2 Version 17 at 0xFEC00000. Enabling APIC mode: Flat. Using 1 I/O APICs Processors: 2 Kernel command line: root=/dev/hda3 ro hdc=ide-scsi noapic ide_setup: hdc=ide-scsi Initializing CPU#0 Detected 1666.741 MHz processor. Console: colour VGA+ 80x25 Calibrating delay loop... 3322.67 BogoMIPS Memory: 1032248k/1048064k available (1889k kernel code, 15428k reserved, 438k data, 276k init, 130560k highmem) Dentry cache hash table entries: 131072 (order: 8, 1048576 bytes) Inode cache hash table entries: 65536 (order: 7, 524288 bytes) Mount cache hash table entries: 512 (order: 0, 4096 bytes) Buffer-cache hash table entries: 65536 (order: 6, 262144 bytes) Page-cache hash table entries: 262144 (order: 8, 1048576 bytes) CPU: L1 I Cache: 64K (64 bytes/line), D cache 64K (64 bytes/line) CPU: L2 Cache: 256K (64 bytes/line) Intel machine check architecture supported. Intel machine check reporting enabled on CPU#0. CPU: After generic, caps: 0383fbff c1cbfbff 00000000 00000000 CPU: Common caps: 0383fbff c1cbfbff 00000000 00000000 Enabling fast FPU save and restore... done. Enabling unmasked SIMD FPU exception support... done. Checking 'hlt' instruction... OK. POSIX conformance testing by UNIFIX mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au) mtrr: detected mtrr type: Intel CPU: L1 I Cache: 64K (64 bytes/line), D cache 64K (64 bytes/line) CPU: L2 Cache: 256K (64 bytes/line) Intel machine check reporting enabled on CPU#0. CPU: After generic, caps: 0383fbff c1cbfbff 00000000 00000000 CPU: Common caps: 0383fbff c1cbfbff 00000000 00000000 CPU0: AMD Athlon(tm) MP 2000+ stepping 02 per-CPU timeslice cutoff: 731.44 usecs. masked ExtINT on CPU#0 ESR value before enabling vector: 00000000 ESR value after enabling vector: 00000000 Booting processor 1/0 eip 2000 Initializing CPU#1 masked ExtINT on CPU#1 ESR value before enabling vector: 00000000 ESR value after enabling vector: 00000000 Calibrating delay loop... 3329.22 BogoMIPS CPU: L1 I Cache: 64K (64 bytes/line), D cache 64K (64 bytes/line) CPU: L2 Cache: 256K (64 bytes/line) Intel machine check reporting enabled on CPU#1. CPU: After generic, caps: 0383fbff c1cbfbff 00000000 00000000 CPU: Common caps: 0383fbff c1cbfbff 00000000 00000000 CPU1: AMD Athlon(tm) Processor stepping 02 Total of 2 processors activated (6651.90 BogoMIPS). Using local APIC timer interrupts. calibrating APIC timer ... ..... CPU clock speed is 1666.8159 MHz. ..... host bus clock speed is 266.6905 MHz. cpu: 0, clocks: 2666905, slice: 888968 CPU0 cpu: 1, clocks: 2666905, slice: 888968 CPU1 checking TSC synchronization across CPUs: passed. Waiting on wait_init_idle (map = 0x2) All processors have done init_idle mtrr: your CPUs had inconsistent fixed MTRR settings mtrr: probably your BIOS does not setup all CPUs PCI: PCI BIOS revision 2.10 entry at 0xfd7c0, last bus=2 PCI: Using configuration type 1 PCI: Probing PCI hardware PCI: Using IRQ router AMD768 [1022/7443] at 00:07.3 BIOS failed to enable PCI standards compliance, fixing this error. Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket Starting kswapd allocated 32 pages and 32 bhs reserved for the highmem bounces VFS: Diskquotas version dquot_6.4.0 initialized Journalled Block Device driver loaded devfs: v1.12c (20020818) Richard Gooch (rgooch@atnf.csiro.au) devfs: devfs_debug: 0x0 devfs: boot_options: 0x1 Installing knfsd (copyright (C) 1996 okir@monad.swb.de). pty: 256 Unix98 ptys configured Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled ttyS00 at 0x03f8 (irq = 4) is a 16550A ttyS01 at 0x02f8 (irq = 3) is a 16550A Real Time Clock Driver v1.10e amd768_rng: AMD768 system management I/O registers at 0x8000. amd768_rng hardware driver 0.1.0 loaded Floppy drive(s): fd0 is 1.44M FDC 0 is a post-1991 82077 Intel(R) PRO/1000 Network Driver - version 5.0.43-k1 Copyright (c) 1999-2003 Intel Corporation. AMD756: dev 8086:100f, router pirq : 4 get irq : 10 PCI: Found IRQ 10 for device 00:0b.0 PCI: Sharing IRQ 10 with 02:00.0 eth0: Intel(R) PRO/1000 Network Connection eepro100.c:v1.09j-t 9/29/99 Donald Becker http://www.scyld.com/network/eepro100.html eepro100.c: $Revision: 1.36 $ 2000/11/17 Modified by Andrey V. Savochkin and others AMD756: dev 8086:1229, router pirq : 3 get irq : 11 PCI: Found IRQ 11 for device 02:08.0 eth1: Intel Corp. 82557/8/9 [Ethernet Pro 100], 00:E0:81:25:10:FF, IRQ 11. Board assembly 567812-052, Physical connectors present: RJ45 Primary interface chip i82555 PHY #1. General self-test: passed. Serial sub-system self-test: passed. Internal registers self-test: passed. ROM checksum self-test: passed (0xd0a6c714). Linux agpgart interface v0.99 (c) Jeff Hartmann agpgart: Maximum main memory to use for agp memory: 941M agpgart: Detected AMD 760MP chipset agpgart: AGP aperture is 64M @ 0xf8000000 Uniform Multi-Platform E-IDE driver Revision: 7.00beta-2.4 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx AMD7441: IDE controller at PCI slot 00:07.1 AMD7441: chipset revision 4 AMD7441: not 100% native mode: will probe irqs later AMD_IDE: Advanced Micro Devices [AMD] AMD-768 [Opus] IDE (rev 04) UDMA100 controller on pci00:07.1 ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:DMA, hdb:pio ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:DMA, hdd:pio hda: WDC WD400JB-00ENA0, ATA DISK drive blk: queue c03e3620, I/O limit 4095Mb (mask 0xffffffff) hdc: SONY DVD RW DRU-500A, ATAPI CD/DVD-ROM drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 ide1 at 0x170-0x177,0x376 on irq 15 hda: attached ide-disk driver. hda: host protected area => 1 hda: 78165360 sectors (40021 MB) w/8192KiB Cache, CHS=4865/255/63, UDMA(100) Partition check: /dev/ide/host0/bus0/target0/lun0: p1 p2 p3 SCSI subsystem driver Revision: 1.00 kmod: failed to exec /sbin/modprobe -s -k scsi_hostadapter, errno = 2 LVM version 1.0.5+(22/07/2002) NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP, IGMP IP: routing cache hash table of 8192 buckets, 64Kbytes TCP: Hash tables configured (established 262144 bind 65536) NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. EXT3-fs: INFO: recovery required on readonly filesystem. EXT3-fs: write access will be enabled during recovery. kjournald starting. Commit interval 5 seconds EXT3-fs: ide0(3,3): orphan cleanup on readonly fs ext3_orphan_cleanup: deleting unreferenced inode 785126 ext3_orphan_cleanup: deleting unreferenced inode 785124 EXT3-fs: ide0(3,3): 2 orphan inodes deleted EXT3-fs: recovery complete. EXT3-fs: mounted filesystem with ordered data mode. VFS: Mounted root (ext3 filesystem) readonly. Mounted devfs on /dev Freeing unused kernel memory: 276k freed Adding Swap: 2000052k swap-space (priority -1) EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,3), internal journal 3ware Storage Controller device driver for Linux v1.02.00.032. AMD756: dev 13c1:1001, router pirq : 1 get irq : 9 PCI: Found IRQ 9 for device 00:08.0 scsi0 : Found a 3ware Storage Controller at 0x1050, IRQ: 9, P-chip: 1.3 scsi0 : 3ware Storage Controller 3w-xxxx: scsi0: AEN: WARNING: Unclean shutdown detected: Unit #0. blk: queue f7e65418, I/O limit 4095Mb (mask 0xffffffff) Vendor: 3ware Model: Logical Disk 0 Rev: 1.0 Type: Direct-Access ANSI SCSI revision: 00 blk: queue f7e65218, I/O limit 4095Mb (mask 0xffffffff) Attached scsi disk sda at scsi0, channel 0, id 0, lun 0 SCSI device sda: 1406637312 512-byte hdwr sectors (-379312 MB) /dev/scsi/host0/bus0/target0/lun0: unknown partition table loop: loaded (max 8 devices) spurious 8259A interrupt: IRQ7. hdc: attached ide-scsi driver. scsi1 : SCSI host adapter emulation for IDE ATAPI devices Vendor: SONY Model: DVD RW DRU-500A Rev: 2.0c Type: CD-ROM ANSI SCSI revision: 02 Attached scsi CD-ROM sr0 at scsi1, channel 0, id 0, lun 0 sr0: scsi3-mmc drive: 32x/32x writer cd/rw xa/form2 cdda tray Uniform CD-ROM driver Revision: 3.12 kjournald starting. Commit interval 5 seconds EXT3 FS 2.4-0.9.19, 19 August 2002 on lvm(58,0), internal journal EXT3-fs: recovery complete. EXT3-fs: mounted filesystem with ordered data mode. 3w-xxxx: scsi0: AEN: INFO: Initialization started: Unit #0. 3w-xxxx: scsi0: AEN: INFO: Initialization complete: Unit #0.