other then the memmap error (in my case device 0:10:0 I get the first
three lines of the driver init and then nothing. the machine
completely locks up (driver version on .54 is 6.2.25 but I've
had this same problem since .50)
here is what I get on 2.4.18, the only difference on the first three lines
between this and 2.5.54 is the driver version number
scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.4
<Adaptec 2940 SCSI adapter>
aic7870: Single Channel A, SCSI Id=7, 16/253 SCBs
Vendor: SEAGATE Model: ST32430N Rev: 0510
Type: Direct-Access ANSI SCSI revision: 02
(scsi0:A:0): 8.064MB/s transfers (8.064MHz, offset 15)
Vendor: RICOH Model: CD-R/RW MP7040S Rev: 1.10
Type: CD-ROM ANSI SCSI revision: 02
scsi0:A:0:0: Tagged Queuing enabled. Depth 15
Attached scsi disk sda at scsi0, channel 0, id 0, lun 0
SCSI device sda: 4197405 512-byte hdwr sectors (2149 MB)
/dev/scsi/host0/bus0/target0/lun0: p1 p2
Attached scsi CD-ROM sr0 at scsi0, channel 0, id 3, lun 0
sr0: scsi3-mmc drive: 20x/20x writer cd/rw xa/form2 cdda tray
David Lang
On Sun, 5 Jan 2003, Justin T. Gibbs wrote:
> Date: Sun, 05 Jan 2003 20:29:07 -0700
> From: Justin T. Gibbs <gibbs@scsiguy.com>
> To: David Lang <david.lang@digitalinsight.com>
> Cc: Paul Rolland <rol@witbe.net>, linux-kernel@vger.kernel.org
> Subject: Re: [2.5.54] Oops IDE-SCSI and failure AIC7xxx
>
> > Ok, but it's the only error message I get and the AIX7xxx driver then
> > fails to initialize.
>
> Can you be just a bit more specific? Actual driver messages are
> usually a big help.
>
> --
> Justin
>
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Tue Jan 07 2003 - 22:00:30 EST