2.5.47 hangs while checking hda on PII laptop

From: Eric Buddington (eric@ma-northadams1b-126.bur.adelphia.net)
Date: Mon Nov 11 2002 - 10:41:53 EST

This is 2.5.47, compiled for a PII laptop (Omnibook 4100) with
gcc-3.2. I fixed an earlier boot panic by disabling IDE-TCQ, but now
it hangs in the hda check (shown below) I waited at least 2 minutes
for it to unhang.

Below is as much of the boot messages as I could capture; I don't know
if the hdc error is significant (the drive had no media), but pulling
the CD-ROM did not prevent the hda hang in a subsequent boot.



ACPI: Interpreter enabled
ACPI: Using PIC for interrupt routing
ACPI: (supports S0 S1 S2 S3 S4 S5)
ACPI: PCI Interrupt Link [LNKA] (IRQs *10)
ACPI: PCI Interrupt Link [LNKB] (IRQs *10)
ACPI: PCI Interrupt Link [LNKC] (IRQs 3 4 5 6 7 9 10 11 12 14 15, disabled)
ACPI: PCI Interrupt Link [LNKD] (IRQs *10)
ACPI: PCI Root Bridge [PCI0] (00:00)
PCI: Probing PCI hardware (bus 00)
ACPI: Embedded Controller [EC0] (gpe 9)
AnCPI: Power Reso [PIDE] (on)
ACPI: Power Resource [PIDE] (on)
pci_bind-0191 [17] acpi_pci_bind : Device 00:00:11.00 not present in PCI
pci_bind-0191 [18] acpi_pci_bind : Device 00:00:12.00 not present in PCI
ACPI: Power Resource [PFAN] (off)
block request queues:
 128 requests per read queue
 128 requests per write queue
 8 requests per batch
 enter congestion at 31
 exit congestion at 33
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
ACPI: PCI Interrupt Link [LNKC] enabled at IRQ 11
PCI: Using ACPI for IRQ routing
PCI: if you experience problems, try using option 'pci=noacpi' or even 'acpi=off
NET4: Frame Diverter 0.46
Total HugeTLB memory allocated, 0
slab: reap timer started for cpu 0
Starting kswapd
aio_setup: sizeof(struct page) = 40
[c11ac040] eventpoll: driver installed.
VFS: Disk quotas vdquot_6.5.1
Journalled Block Device driver loaded
devfs: v1.22 (20021013) Richard Gooch (rgooch@atnf.csiro.au)
devfs: devfs_debug: 0x0
devfs: boot_options: 0x1
Capability LSM initialized
Initializing Cryptographic API
Limiting direct PCI/PCI transfers.
Serial: 8250/16550 driver $Revision: 1.90 $ IRQ sharing enabled
ytts/0 at I/O 0x3f8 (irq = 4) is a 16550A
pty: 256 Unix98 ptys configured
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
hdc: _NEC CDR-2800B, ATAPI CD/DVD-ROM drive
ide1 at 0x170-0x177,0x376 on irq 15
hdc: ATAPI 24X CD-ROM drive, 128kB Cache
Uniform CD-ROM driver Revision: 3.12
end_request: I/O error, dev hdc, sector 0
hda: 3909MB, CHS=993/128/63
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

This archive was generated by hypermail 2b29 : Fri Nov 15 2002 - 22:00:22 EST