Re: hardware raid (adaptec 1200A)?

From: Wilfried Weissmann (Wilfried.Weissmann@gmx.at)
Date: Fri Nov 16 2001 - 05:06:32 EST


nbecker@fred.net wrote:
>
> I'm setting up a new machine with a pair of IDE drives connected to
> adaptec 1200A controller. I defined a RAID-0 array using the adaptec
> bios, but linux doesn't see it as a single drive. It just sees two
> drive, hde and hdg (each at their physical sizes). Any hints?

I think the adaptec 1200A is just another low-cost
not-quite-hardware-raid controller. As far as I have heared it is based
on Highpoint-Tech's HPT370. There is raid-0 support implemented in the
kernel.

be sure to enable CONFIG_BLK_DEV_ATARAID_HPT=y

The volumes should show up as /dev/ataraid/d[0-9]p[0-9] (major
blockdevice number 114).

bye,
Wilfried

-- 
Terorists crashed an airplane into the server room, have to remove
/bin/laden. (rm -rf /bin/laden)
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/



This archive was generated by hypermail 2b29 : Fri Nov 23 2001 - 21:00:13 EST