Looking for lscpci output I have found that amount of detected
memory on my SVGA Tseng ET6000 is incorrect :
00:0f.0 VGA compatible controller: Tseng Labs Inc ET6000 (rev 30)
(prog-if 00 [V
GA])
Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop-
ParErr- Step
ping- SERR- FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B- ParErr- DEVSEL=slow
>TAbort- <TAbort-
<MAbort- >SERR- <PERR-
Interrupt: pin A routed to IRQ 11
Region 0: Memory at e5000000 (32-bit,
non-prefetchable)[size=16M]
Region 1: I/O ports at e800 [size=256]
Expansion ROM at <unassigned> [disabled] [size=16M]
The card has only 2 M - and this incorrect detection makes
problems in use mtrr under XFree4.x .
Is it hardware problem or error in PCI detection routines ?
--------------------------------------------------------
Marek Mentel mmark@koala.ichpw.zabrze.pl 2:484/3.8
INSTITUTE FOR CHEMICAL PROCESSING OF COAL , Zabrze , POLAND
NOTE: my opinions are strictly my own and not those of my employer
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Sun Sep 23 2001 - 21:00:19 EST