Hello Doug,
Monday, April 23, 2001, 9:54:35 PM, you wrote:
DL> Eugene Kuznetsov wrote:
>>
>> Hello,
>>
>> I am a happy owner of Intel D815EEA2 mother board. This board
>> comes with integrated AC-97 audio. When I try to load i810_audio
>> driver for it, driver identifies the device as
>> "Intel 810 + AC97 Audio, version 0.02, 19:43:23 Apr 20 2001
>> i810: Intel ICH2 found at IO 0xef00 and 0xe800, IRQ 6
>> ac97_codec: AC97 Audio codec, id: 0x4144:0x5360 (Analog Devices
>> AD1885)"
>> and later brings the system into one of three possible conditions.
>> A) a bit later it says:
>> i810_audio: 11168 bytes in 50 milliseconds
>> i810_audio: setting clocking to 41260 to compensate
>> In this case everything is fine ( 16-bit sound is played correctly, I
>> don't need much more ... ).
DL> Write that number down. You can add it to your /etc/modules.conf file if you
DL> like. If the new driver sees that the clocking variable has been set to
DL> anything other than 48000 it doesn't run the clocking autodetect routine.
>> B) It says:
>> i810_audio: 65528 bytes in 50 milliseconds
>> i810_audio: setting clocking to 7032 to compensate
>> In this case the sound does not work at all - sound card does not
>> produce anything but silence. With versions of kernel up to 2.4.3 I
>> also received a lot of "DMA buffer overrun on send" messages in dmesg
>> when playing anything.
>> C) Last condition is relatively rare. It says something similar to
>> case A, but number of bytes is multiple of 11168 and clocking is lower
>> ( e.g. 13753 = 41260/3 ). Sound card works, but output quality is
>> quite low.
>> Which of cases A)..C) takes place, seems to be random ( I haven't
>> noticed any pattern ). However, attempts to do rmmod/insmod
>> do not have any effect. I have to at least reboot the system a few
>> times to bring the sound to working state.
DL> Both B and C are cases of the whole chip acting flat busted. I would suspect
DL> that possibly Win2k drivers set this thing up some way that we don't recover
DL> from. Is there any pattern like maybe "I listen to X in Win2k then reboot to
DL> linux and sound is screwed" or something like that?
DL> Also, when it does
DL> happen, does shutting down and then actually powering the machine off
DL> (possibly by going so far as to unplug the machine for 5 seconds or so to
DL> overcome any low power state savings on modern motherboards) make it reliably
DL> come back instead of having to reboot multiple times?
DL> Does this ever happen
DL> if you just unload/reload the module without rebooting inbetween (aka, does
DL> the linux driver module sometimes trigger the problem)?
Maybe there is a pattern: I remember that case B occured more
frequently after soft reboot from Win2k. I had case C one time
immediately after turning the computer on and booting directly into
Linux. I will do some more testing about these three
questions and tell you the results later today.
DL> Finally, when B or C
DL> does happen, can you get the module to work by loading the module with the
DL> clocking= option set to the correct clocking value from A?
No.
I want to tell you that I received an advice from one of list subscribers
and tried installing ALSA drivers for the chip. They work without any
of described problems.
-- Best regards, Eugene mailto:divx@euro.ru or sparky@projectmayo.com [Team GADGET] [Team Two Divided By Zero] [Team Hackzone.ru]- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Mon Apr 30 2001 - 21:00:10 EST