Linux version 2.4.0 (torvalds@transmeta.com) (gcc version egcs-2.91.66 19990314/Linux (egcs-1.1.2 release)) #3 Wed Jan 24 17:38:55 EST 2001 BIOS-provided physical RAM map: BIOS-e820: 000000000009fc00 @ 0000000000000000 (usable) BIOS-e820: 0000000000000400 @ 000000000009fc00 (reserved) BIOS-e820: 000000000000c000 @ 00000000000c0000 (reserved) BIOS-e820: 0000000003eec000 @ 0000000000100000 (usable) BIOS-e820: 0000000000004000 @ 0000000003fec000 (reserved) BIOS-e820: 0000000000200000 @ 00000000ffe00000 (reserved) Scan SMP from c0000000 for 1024 bytes. Scan SMP from c009fc00 for 1024 bytes. Scan SMP from c00f0000 for 65536 bytes. Scan SMP from c009fc00 for 4096 bytes. On node 0 totalpages: 16364 zone(0): 4096 pages. zone(1): 12268 pages. zone(2): 0 pages. mapped APIC to ffffe000 (01111000) Kernel command line: auto BOOT_IMAGE=2.4.0-1 ro root=309 Initializing CPU#0 Detected 548.183 MHz processor. Console: colour VGA+ 80x25 Calibrating delay loop... 1094.45 BogoMIPS Memory: 62012k/65456k available (1119k kernel code, 3056k reserved, 427k data, 1 92k init, 0k highmem) Dentry-cache hash table entries: 8192 (order: 4, 65536 bytes) Buffer-cache hash table entries: 1024 (order: 0, 4096 bytes) Page-cache hash table entries: 16384 (order: 4, 65536 bytes) Inode-cache hash table entries: 4096 (order: 3, 32768 bytes) VFS: Diskquotas version dquot_6.4.0 initialized CPU: Before vendor init, caps: 0383f9ff 00000000 00000000, vendor = 0 CPU: L1 I cache: 16K, L1 D cache: 16K CPU: L2 cache: 256K Intel machine check architecture supported. Intel machine check reporting enabled on CPU#0. CPU: After vendor init, caps: 0383f9ff 00000000 00000000 00000000 CPU: After generic, caps: 0383f9ff 00000000 00000000 00000000 CPU: Common caps: 0383f9ff 00000000 00000000 00000000 CPU: Intel Pentium III (Coppermine) stepping 06 Enabling fast FPU save and restore... done. Enabling unmasked SIMD FPU exception support... done. Checking 'hlt' instruction... OK. POSIX conformance testing by UNIFIX mtrr: v1.37 (20001109) Richard Gooch (rgooch@atnf.csiro.au) mtrr: detected mtrr type: Intel PCI: PCI BIOS revision 2.10 entry at 0xfc06e, last bus=8 PCI: Using configuration type 1 PCI: Probing PCI hardware Unknown bridge resource 2: assuming transparent Unknown bridge resource 2: assuming transparent PCI: Using IRQ router PIIX [8086/244c] at 00:1f.0 got res[f2000000:f2000fff] for resource 0 of Texas Instruments PCI4451 PC card Cardbus Controller got res[f2001000:f2001fff] for resource 0 of Texas Instruments PCI4451 PC card Cardbus Controller (#2) Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 DMI 2.3 present. 60 structures occupying 2270 bytes. DMI table at 0x000F63D0. Starting kswapd v1.8 pty: 256 Unix98 ptys configured Uniform Multi-Platform E-IDE driver Revision: 6.31 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx PCI_IDE: unknown IDE controller on PCI bus 00 device f9, VID=8086, DID=244a PCI_IDE: chipset revision 2 PCI_IDE: not 100% native mode: will probe irqs later ide0: BM-DMA at 0xbfa0-0xbfa7, BIOS settings: hda:DMA, hdb:DMA ide1: BM-DMA at 0xbfa8-0xbfaf, BIOS settings: hdc:pio, hdd:pio hda: IBM-DJSA-220, ATA DISK drive hdb: TOSHIBA DVD-ROM SD-C2402, ATAPI CDROM drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 hda: 39070080 sectors (20004 MB) w/1874KiB Cache, CHS=2432/255/63 hdb: ATAPI 24X DVD-ROM drive, 128kB Cache, UDMA(33) Uniform CD-ROM driver Revision: 3.12 Partition check: hda: hda1 hda2 hda3 < hda5 hda6 hda7 hda8 hda9 hda10 hda11 > Floppy drive(s): fd0 is 1.44M FDC 0 is a post-1991 82077 Serial driver version 5.02 (2000-08-09) with MANY_PORTS SHARE_IRQ SERIAL_PCI ena bled ttyS00 at 0x03f8 (irq = 4) is a 16550A ttyS01 at 0x02f8 (irq = 3) is a 16550A eepro100.c:v1.09j-t 9/29/99 Donald Becker http://cesdis.gsfc.nasa.gov/linux/driv ers/eepro100.html eepro100.c: $Revision: 1.35 $ 2000/11/17 Modified by Andrey V. Savochkin and others eth0: OEM i82557/i82558 10/100 Ethernet, 00:20:E0:64:8C:0A, IRQ 11. Board assembly 727095-002, Physical connectors present: RJ45 Primary interface chip i82555 PHY #1. General self-test: passed. Serial sub-system self-test: passed. Internal registers self-test: passed. ROM checksum self-test: passed (0x04f4518b). Receiver lock-up workaround activated. Linux agpgart interface v0.99 (c) Jeff Hartmann agpgart: Maximum main memory to use for agp memory: 27M agpgart: agpgart: Detected an Intel i815, but could not find the secondary devic e. agpgart: no supported devices found. Linux PCMCIA Card Services 3.1.22 options: [pci] [cardbus] [pm] PCI: Found IRQ 11 for device 02:0f.0 PCI: The same IRQ used for device 00:1f.2 PCI: The same IRQ used for device 02:0f.1 PCI: The same IRQ used for device 02:0f.2 PCI: Found IRQ 11 for device 02:0f.1 PCI: The same IRQ used for device 00:1f.2 PCI: The same IRQ used for device 02:0f.0 PCI: The same IRQ used for device 02:0f.2 Intel PCIC probe: not found. usb.c: registered new driver usbdevfs usb.c: registered new driver hub Yenta IRQ list 0698, PCI irq11 Socket status: 30000006 Yenta IRQ list 0698, PCI irq11 Socket status: 30000006 PCI: Found IRQ 11 for device 00:1f.2 PCI: The same IRQ used for device 02:0f.0 PCI: The same IRQ used for device 02:0f.1 PCI: The same IRQ used for device 02:0f.2 PCI: Setting latency timer of device 00:1f.2 to 64 uhci.c: USB UHCI at I/O 0xbce0, IRQ 11 uhci.c: detected 2 ports usb.c: new USB bus registered, assigned bus number 1 hub.c: USB hub found hub.c: 2 ports detected NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP, IGMP IP: routing cache hash table of 512 buckets, 4Kbytes TCP: Hash tables configured (established 4096 bind 4096) NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. ACPI: System description tables found ACPI: System description tables loaded ACPI: Subsystem enabled ACPI: System firmware supports: C2 ACPI: System firmware supports: S0 S1 S3 S4 S5 AC Adapter: found Cmbatt: Battery socket 0 empty Cmbatt: Battery socket 1 occupied VFS: Mounted root (ext2 filesystem) readonly. Freeing unused kernel memory: 192k freed Adding Swap: 265064k swap-space (priority -1) cs: IO port probe 0x1000-0x17ff: clean. cs: IO port probe 0x0100-0x04ff: excluding 0x170-0x177 0x280-0x287 0x370-0x377 0 x4d0-0x4d7 cs: IO port probe 0x0a00-0x0aff: clean. [drm:r128_init] *ERROR* Cannot initialize agpgart module.