Re: Problems with ov511/USB on test13-pre7

From: Erik Mouw (J.A.K.Mouw@ITS.TUDelft.NL)
Date: Sat Dec 30 2000 - 19:44:16 EST

On Sat, Dec 30, 2000 at 11:24:40PM +0000, wrote:
> Problems with Creative Webcam III. This worked fine
> in test13-pre4, haven't tried pre5 & 6.


> USB controller is:
> 00:04.2 USB Controller: VIA Technologies, Inc. UHCI USB (rev 10) (prog-if
> 00 [UHCI])
> Subsystem: Unknown device 0925:1234
> Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop-
> ParErr- Stepping- SERR- FastB2B-
> Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
> <TAbort- <MAbort- >SERR- <PERR-
> Latency: 32, cache line size 08
> Interrupt: pin D routed to IRQ 5
> Region 4: I/O ports at d400 [size=32]
> Capabilities: [80] Power Management version 2
> Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA
> PME(D0-,D1-,D2-,D3hot-,D3cold-)
> Status: D0 PME-Enable- DSel=0 DScale=0 PME-

This looks like some kind of UHCI problem. I have the same camera
(well, it is a Creative Webcam plus, but same chipset) with an Intel
UHCI controller and I haven't seen any errors. Here is my USB

00:07.2 USB Controller: Intel Corporation 82440MX USB Universal Host
Controller (prog-if 00 [UHCI])
        Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
        Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium
>TAbort- <TAbort- <MAbort- >SERR- <PERR-
        Latency: 64
        Interrupt: pin D routed to IRQ 11
        Region 4: I/O ports at fcc0 [size=32]


J.A.K. (Erik) Mouw, Information and Communication Theory Group, Department
of Electrical Engineering, Faculty of Information Technology and Systems,
Delft University of Technology, PO BOX 5031,  2600 GA Delft, The Netherlands
Phone: +31-15-2783635  Fax: +31-15-2781843  Email:
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to
Please read the FAQ at

This archive was generated by hypermail 2b29 : Sun Dec 31 2000 - 21:00:14 EST