Hi!
I've just mounted an Adaptec 2930 SCSI ultra-narrow controller into my
"new" G3. It works fine with Linux, but it refuse to go at 20MB/s as
it should. At boot time it tells 10MB/s and it reaches about 9.5MB/s
raw transfer. I connected a 9GB IBM U2W harddisk and it correctly runs
at 20MB/s with MacOS. It's the only device on the SCSI bus.
Is there any boot parameter or so to make it work in "ultra" mode ?
Bye.
Giuliano Pochini ->)|(<- Shiny Corporation {AS6665} ->)|(<-
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Fri Jun 23 2000 - 21:00:21 EST