Let me put one back in........
> PDC20262: (U)DMA Burst Bit ENABLED Primary MASTER Mode Secondary MASTER Mode.
This automaticly set, because the driver did not not do it correct.
Therefore both drives are present.
Your FastTrak is hiding a drive! You have a RAID ! mirror setup??
> ide2: BM-DMA at 0xa000-0xa007, BIOS settings: hde:pio, hdf:pio
> hda: CD-ROM CDU701, ATAPI CDROM drive
> hde: WDC WD102BA, ATA DISK drive
> ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
> ide2 at 0xb400-0xb407,0xb002 on irq 10
> hde: 20028960 sectors (10255 MB) w/2048KiB Cache, CHS=19870/16/63,
> hda: ATAPI 14X CD-ROM drive, 128kB Cache, DMA
> Uniform CD-ROM driver Revision: 3.08
> Partition check:
> hde: hde1
> Why is there only one channel showing up? Shouldn't there be an
> "ide3" there too? It is only seeing one drive (hde), so I imagine
> when ide3 shows up hdg will also show up???
> Is my configuration incorrect?
> To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
> the body of a message to firstname.lastname@example.org
> Please read the FAQ at http://www.tux.org/lkml/
The Linux ATA/IDE guy
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to email@example.com
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Wed May 31 2000 - 21:00:13 EST