I am compiling cs4232 and the YM3812/OPL-3 driver into the
kernel. I have specified the parameters for those drivers
in the lilo.conf file:
append = "cs4232=0x530,5,1,0,0x300,10 opl3=0x388"
Note that these are the same settings I needed to have
my sound card work with the drivers as modules. However,
now when I boot I get the following messages:
Mar 10 18:41:17 spot kernel: ad1848/cs4248 codec driver Copyright (C) by
Hannu Savolainen 1993-1996
Mar 10 18:41:17 spot kernel: YM3812 and OPL-3 driver Copyright (C) by
Hannu Savolainen, Rob Hooft 1993-1996
Mar 10 18:41:17 spot kernel: adlib: must specify I/O address.
Mar 10 18:43:04 spot kernel: Sound: DMA (output) timed out - IRQ/DRQ
config error?
I could try adding "adlib=<value>" but I don't know what the
value should be or why I need to specify it now, when I never
have in the past.
Thanks,
Miles
Alan Cox wrote:
>
> > Please excuse my ignorance here: Is the CS4232 card not ISAPNP
> > enabled? sndconfig never detects my card (I can send system info
> > if desired). Would this be a bug in sndconfig?
> >
> > I have enabled PNP and ISA PNP in the 2.3 configuration. Should that
> > just take care of it or do I need to install usermode stuff as well.
>
> The 2.3.x doesnt yet have the code for the cs423x PnP (and it depends how
> it is strapped if its ISA PnP or not)
>
> ALan
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Wed Mar 15 2000 - 21:00:18 EST